Bucket Swamp Cooler for Burning Man - Bucket Swamp Cooler for Burning Man

Navigation Tips:
RIGHT Arrow	:	Go to Next page
LEFT Arrow	:	Go to Previous page
Page UP	:	Go up one level
HOME	:	Go to First page
END	:	Go to Last page
S, s	:	Toggle start/stop slide show (not in index)
ESC	:	Stop slide show (not in index)
I, i	:	Toggle exif info (not in index)
H, h	:	Toggle help tips (this layer!)

First page

Previous page

HOME

Next page

Last page

Help

IMG_0607 * 3648 x 2736 * (2.63MB)

IMG_0609 * 3648 x 2736 * (2.6MB)

IMG_0610 * 3648 x 2736 * (2.61MB)

IMG_0607
Finished drip ring

IMG_0609
Drill water holes: Using a small drill bit (1/16"), put a ring of holes around the bottom of the drip ring. Angle the holes ever so slightly to the inside, so water doesn't squirt outwards.

IMG_0610
Finished ring: The last bit of tubing can be eyeballed. Just be sure it reached to the pump at the bottom of the bucket. Very easy to cut with a box knife, so experiment!

IMG_0608 * 3648 x 2736 * (2.83MB)

IMG_0611 * 3648 x 2736 * (2.29MB)

IMG_0613 * 3648 x 2736 * (2.76MB)

IMG_0608
Cord Routing: The power cord for the pump can route under the mat and shade cloth, and out of one of the bucket ventilation holes. All so you can still close the lid.

IMG_0611
Finished interior: Almost ready to go!

IMG_0613
Water Jets: Adding water and turning on the pump, you can see the water squirting out of the holes and wetting down the mat... perfect!

First page

Previous page

HOME

Next page

Last page

Help

Album last updated on 7/27/10 3:28 PM

Powered by and skin

(c) 2010 K. Kalani Patterson